OneCNC Germany at EuroMold 2011


Euromold_2011_1

OneCNC Germany exibited at EuroMold in Frankfurt 29 November - 2 December 2011. The next generation of OneCNCXR5 was a preview to provide an insight into the development of the next generation available. OneCNC Germany has exhibited at the show for the last 6 years and is a major show at the OneCNC calendar.

Euromold_2011_4

EuroMold 2011 was very busy as usual keen to see the latest products from OneCNC Germany with many users and potential customers. Euromold again the latest technologies and forms of German manufacturing technologies displayed. This is a very mature show and attracts large mold makers from Germany and international companies.

A stand near OneCNC are shown how far the energy savings in engineering has come up with the display of a motorcycle that has the ability to cover 995 kilometers on a single liter of fuel.

Euromold_2011_3

OneCNC Germany have experienced engineers for online training, online demonstration or on-site training for the complete range of products OneCNC.

Contact OneCNC Germany >>

OneCNC Benelux at METAVAK November 8 to 10

OneCNC Benelux unveiled a new display stand for METAVAK show in Gorinchem. This was a very successful show for OneCNC due to the fact that the products are now also established in the Benelux. Neil Day OneCNC Benelux Manager (far right), and 2 more OneCNC engineers were busy demonstrating the OneCNC products during the show.

Stand_busy
OneCNC Benelux have 5 experienced engineers to assist with training and assistance on all OneCNC including up to axis simultaneous milling and multi-function lathes.

For more information or an on-site demonstration of how OneCNC could improve your business contact OneCNC Benelux.

OneCNC Benelux >>